Bosch CAD 12 Instrucciones De Manejo página 45

Tone and display
Tone and display
Adjusting the treble (TREB), middle
(MID) and bass (BASS)
f Press the AUD M button to open the
menu.
f Press the AUD M button repeatedly until
"BASS", "MID" or "TREB" appears on the
display along with the current setting.
f Turn the volume control B to the left or
right in order to set the bass, middle or
treble levels to between +7 and -7.
In order to leave the menu,
f press the AUD M button, repeatedly if
necessary.
Adjusting the left/right volume bal-
ance (BAL)
f Press the AUD M button to open the
menu.
f Press the AUD M button repeatedly until
"BAL" appears on the display along with
the current setting.
f Turn the volume control B to the left or
right in order to set the volume balance to
between +10 and -10.
In order to leave the menu,
f press the AUD M button, repeatedly if
necessary.
Robert Bosch Car Multimedia GmbH
Switching the loudness (LD) on
and off
f Press the AUD M button to open the
menu.
f Press the AUD M button repeatedly until
"LD" appears on the display, along with
the current setting "ON" or "OFF".
f Turn the volume control B to the left or
right in order to switch the loudness on or
off.
In order to leave the menu,
f press the AUD M button, repeatedly if
necessary.
Resetting the tone
You can reset all the tone adjustments to their
factory default settings (TREB, MID, BASS,
BAL: 0; LD: OFF).
f Press the AUD M button to open the
menu.
f Press the AUD M button repeatedly until
"RESET N" appears in the display.
f Turn the volume control B to the right in
order to select "RESET Y".
After about 2 seconds all the tone adjustments
will be reset.
In order to leave the menu,
f press the AUD M button, repeatedly if
necessary.
Note:
You can reset the tone adjustments at
any time by holding down the AUD
M button for longer than 2 seconds.
This resets all tone adjustments for
the audio source being used at the
time.
7 620 210 015/020-022 | 06.2015
en | 45