Publicidad
Idiomas disponibles
Idiomas disponibles
Product Information
1. This is a Universal booster cushion Enhanced Child
Restraint System, It is approved according to UN
Regulation No.129, for use in i-Size compatible and
universal vehicle seating positions as indicated by vehicle
manufacturers in the vehicle user's manual.
2. If in doubt, consult the Enhanced Child Restraint System
manufacturer or the retailer.
Product
Booster seat
Materials
Plastics, Metal, Fabrics
Patent No.
Patents pending
Suitable for Child height 135cm-150cm
(Reference age 7-12 years)
Installation Forward facing (in vehicle travel direction)
Concerns on Installation
1
3
See images
-
Installation with 3-point-belt
4
10
See images
-
6
Insert the end of shoulder belt positioning clip
webbing into the hole on the base.
! Please check the direction of shoulder harness anchor
as
10
to avoid hurting the child's back if shoulder
harness anchor is in the opposite direction.
! Pull the shoulder belt positioning clip webbing to make
sure the webbing fixed on the base.
7
Make the webbing and clip wind round bar, then
tension webbing.
8
Slide shoulder harness anchor to adjust webbing
length.
7
! Place through the shoulder belt into the shoulder belt
positioning clip, Slide the shoulder belt positioning clip
to make sure the clip is close to child's shoulder,
buckle the vehicle safety belt.
! To achieve the safest installation, we suggest the
shoulder belt positioning clip should be level with the
highest point of the child's shoulder.
DO NOT position vehicle belt over top of the armrests. It
must pass underneath the armrests.
The booster can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the booster
securely.
9
-4
! Place a booster firmly against the back of a forward-
facing vehicle seat equipped with a lap/shoulder belt.
! After your child is placed in this booster, the safety belt
must be used correctly, and ensure that any lap strap
is worn low down, so that the pelvis is firmly engaged.
9
! Any straps holding the booster to the vehicle should
be tight , any straps restraining the child should be
adjusted to the child's body, and the straps should not
be twisted.
Rear view of child sitting in seat.
! The shoulder belt positioning clip must through the
horizontal bar of the base farthest from where the
vehicle shoulder belt lays across the child.
! Please store shoulder belt positioning clip on the
bottom of base when don't use it.
Use Cupholders
11
See image
Detach Soft Goods
12
See image
9
-1
9
-3
-2
9
10
8
Publicidad
