KALLISTA P22121 Guia De Instalacion página 7

Stopper
Stopper
Nut
Body Nut
Rod
Seal
Body
Seal Hole
Apply 3 layers of
Tailpiece
sealant tape and a
small bead of pipe
sealant to threads.
5. Complete the Drain Installation
For regular installations, insert the short end of the rod into the
body seal hole and under the stopper. Secure with the body nut.
Remove and adjust the stopper so it lifts about 3/8" (1 cm) when
opened. To adjust, loosen the stopper nut and shorten or lengthen
the stopper as needed. Tighten the stopper nut.
Apply three layers of thread tape and a small bead of pipe
sealant to the tailpiece threads.
Thread the tailpiece to the body and tighten securely.
Slide one end of the clip onto the rod. Slide the link onto the rod
with the thumbscrew facing the back of the fixture.
Squeeze the other end of the clip, aligning the hole with the rod.
Move the link to the proper position by squeezing the clip and
sliding it along the rod.
Insert the pop-up rod into the hole in the faucet and then into the
hole in the link.
Tighten the thumbscrew onto the link so the pop-up rod knob
extends above the pop-up rod hole.
Kallista
All manuals and user guides at all-guides.com
Faucet
Rod
Clip
7
Thumb
Screw
Link
1004811-2-A