Berner PRO-100 LOTMULTI Instrucciones De Manejo página 10

REFILL:
2.1 Make sure the ON/OFF lever is in the OFF position before you fill.
2.2 Adapters are not normally required for filling.
2.3 To fill, hold the refill bottle as shown (gas transfer is based on gravitational principle).
2.4 Stop the refilling process when gas is again coming out of the gas tank.
IGNITION PROCESS:
3.A Slide the ON/OFF ignition lever to ON to allow gas to flow out. let.
3.B Now push this lever as far as it will go to ignite. Then release the lever so that it returns
to the ON position. arrived.
3.C To switch off again, push the ON/OFF lever all the way down. below.
ATTENTION:
3.C
Do not touch the tip, tip
housing or the edge of the gland
while the soldering iron is is hot.
Danger of burns!
3.D
3.C
Ignite the
soldering iron not if no
tip is screwed on. This
may cause damage to
the unit.
-
EN
2.4
3.A
3.B
ON
OFF
3.C
-
3.D
-