Berner PRO-100 LOTMULTI Instrucciones De Manejo página 11

HOW DO I USE THE SOLDERING TIP?
3.1.1 Make sure that the hot air outlet hole is facing upwards - as shown.
3.1.2 Set the throttle control lever to the middle position.
3.1.3 Slowly push the ON/OFF - ignition lever all the way up and then let the lever out
(like point 3A and 3B).
3.1.4 You will hear the gas flowing and the tip housing window will turn
orange after 1 or 2 seconds. If not, repeat point 3.1.3.
3.1.5 The soldering tip temperature can be varied using the gas regulation lever.
3.1.6 To switch off as in point 3.C. It is not necessary to adjust the throttle control
lever after the soldering iron has been switched off.
HOW TO USE THE HOT AIR SYRINGE
3.2.1 Unscrew the tip and tip housing at the fixing screw.
3.2.2 Mount the blower tip in the place of the removed soldering tip.
3.2.3 Ignite the gas by means of the ON/OFF ignition lever (as point 3.A and 3.B).
3.2.4 Regulate the flame length. Do not switch on to the maximum, otherwise the flame
may start to flicker or go out. 3.2.5 To switch off the unit, do the same as when
using the soldering tip. (as point 3.1.6).
OTHER PEAK
3.3 All tips are used in the same way (as point 3.1.6).
SETTING
4.1 The temperature of the tip can be adjusted by operating the
gas control lever according to the -/+ signs on the body of the soldering iron.
4.2 Normally, you set the throttle control lever to the middle position. position when
you solder or weld.
4.3 It is not necessary for the tip to be red hot to be safely that an optimal working
temperature has been reached.
EN
3.1
ON
OFF
-
3.2
Lift Loosen
4
-