Textron RANSOMES LMAA937A Manual De Seguridad página 6

GB
VERTI-GROOM ATTACHMENT
SPECIFICATION 51
Number of blades 31
Diameter 72mm (253/64in)
Blade spacing 15mm (19/32in)
Depth adjustment 8mm (5/16in) above front roll to
Speed of rotation 2500 rpm max.
ADJUSTMENTS
Setting up the machine after fitting the Verti-Groom
attachment.
VERTI-GROOM SETTINGS (Fig.1.0)
The Verti-Groom reel should be parallel to the bed
knife.
1. Make sure that the Verti-Groom
handwheels are in the down position.
2. To set the Verti-Groom height use the
height of cut setting bar. Release the lock
nuts (A Fig.1.0) and using the
handwheels (B Fig.1.0) turn in the
desired direction clockwise to raise the
Verti-Groom reel, anti-clockwise to lower
the Verti-Groom reel. A packer of the
required thickness, up to 5mm (3/16in)
can be used on the setting bar to obtain
the required Verti-Groom reel height.
3. When both sides of the Verti-Groom have
been adjusted and are parrallel retighten
the locknuts.
NOTE:
It is recommended that the Verti-Groom reel is
initially set at a position 3mm (1/8in) above the
front roll. The machine should be tried on a green
and if necessary the Verti-Groom reel position
altered up or down to give the desired finish.
VERTI-GROOM DRIVE BELT
This is located on the RH side of the machine and
is accessed by removing the lid from the drive belt
housing.
TO ADJUST THE VERTI-GROOM DRIVE BELT
(Fig.1.1)
Loosen off the belt tensioner and tension drive belt
by moving the belt tensioner up or down in the
adjusting slot so a deflection of 5mm (3/16in) is
achieved with a force of 2.2Kgs (5lbs) in the centre
of the lower span A (Fig.1.1).
GB-4
SAFETY AND OPERATION/MAINTENANCE AND PARTS MANUAL
61
35
level with front roll
VERTIGROOM ATTACHMENT
Fig 1.0
Fig 1.1