Be very careful about product transportation.
• Only one person should not carry the product if it weighs more than 20 kg.
• Some products use PP bands for packaging. Do not use any PP bands for a means of transportation. It is dangerous.
• Do not touch the heat exchanger fins. Doing so may cut your fingers.
• When transporting the outdoor unit, suspending it at the specified positions on the unit base. Also support the outdoor unit
at four points so that it cannot slip sideways.
Safely dispose of the packing materials.
• Packing materials, such as nails and other metal or wooden
parts, may cause stabs or other injuries.
• Tear apart and throw away plastic packaging bags so that chil-
dren may not play with them. If children play with a plastic bag
which was not torn apart, they face the risk of suffocation.
Do not touch any of the refrigerant piping during and
after operation.
• It can cause a burn or frostbite.
Do not directly turn off the main power switch after
stopping operation.
• Wait at least 5 minutes before turning off the main power
switch. Otherwise it may result in water leakage or other
problems.
Use a firm stool or ladder when cleaning or maintain-
ing the air conditioner.
• Be careful and avoid personal injury.
Avoid a place where rain may enter since the HR unit
is for indoor
• There is risk of property damage, failure of product or elec-
tric shock.
Turn on the power at least 6 hours before starting
operation.(In case of outdoor
temperature below 10°C)
• Starting operation immediately after turning on the main
power switch can result in severe
damage to internal parts. Keep the power switch turned on
during the operational season.
Do not operate the air conditioner with the panels or
guards removed.
• Rotating, hot, or high-voltage parts can cause injuries.
Auto-addressing should be done in condition of connect-
ing the power of all indoor and outdoor units. Auto-
addressing should also be done in case of changing the
Indoor unit PCB.
Do not insert hands or other objects through the air
inlet or outlet while the air conditioner is plugged in.
• There are sharp and moving parts that could cause per-
sonal injury.
Install the HR unit at a place in which it is not affected
by operation mode changing noise.
• Installation within cell such as meeting room etc, may dis-
turb business due to noise.
Safety Precautions
Owner's Manual 5