Publicidad
Idiomas disponibles
Idiomas disponibles
• The user assumes all risks of assembling and operating gas heater. Not heeding the warnings and instructions of this manual can result in sever bodily harm,
death or material damage. If you don't read this user manual or if you cannot fully understand it, please ask your specialized dealer. The manufacturer or supplier
assumes no liability for negligent user behavior.
• When not heeding the instructions and information in this manual or in case of improper usage outside of the intended usage purposes, the manufacturer rejects
any liability for product damage.
• Do not attempt any changes to the device in any way to apply. Incorrect installation, improper use, changes or modifications to the device can cause injury or
damage. Manufacturer and importer do not accept any responsibility for this.
• Do not connect the gas cylinder directly to the unit without the regulator.
• The hoses or the flexible hose must be replaced within the prescribed intervals.
• Use only the gas type and bottle type specified in this manual.
CAUTION
• The LP regulator/hose assembly must be located out of pathways where people may trip over it or in area
where the hose will not be subject to accidental damage.
• Any guard or other protective device removed for servicing the heater must be replaced before operating
the heater.
• Adults and children must stay away from high temperature surface to avoid burns or clothing ignition.
• Children should be carefully supervised when they are in the area of the heater.
• Clothing or other flammable materials should not be hung on the heater or placed on or near the heater.
• Change the gas cylinder in an amply ventilated area, away from any ignition source (candle, cigarettes, other
flame producing appliances, ...).
• Check that the regulator seal is correctly fitted and able to fulfill its function showed as photo right.
• Do not obstruct the ventilation holes of the cylinder housing.
• Close the gas supply at the valve of the gas cylinder or the regulator after use.
• In the event of gas leakage, the appliance shall not be used or if alight, the gas supply shall be shut off and
the appliance shall be investigated and rectified before it is used again.
• Check the hose at least once per month, each time the cylinder is changed, or each time before long time no use.
• If it shows signs of cracking, splitting or other deterioration it shall be exchanged for new hose of the same length and of the equivalent
quality.
• The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
• Read the instructions before using this appliance. The appliance must be installed in accordance with the instructions and local regulations.
• For connection of hose and regulator, and connection of regulator and hose, please refer to photo shown above.
HEATER STAND AND LOCATION
• The heater is suitable for outdoor use only. Always ensure that adequate fresh air ventilation is provided.
• Always maintain proper clearance to non protected combustible materials i.e. top 100 cm and sides
100 cm minimum.
• Heater must be placed on level firm ground.
• Never operate heater in an explosive atmosphere like in areas where gasoline or other flammable
liquids or vapors are stored.
GAS REQUIREMENTS
• Use propane, butane or their mixtures gas only.
• The pressure regulator and hose assembly to be used must conform to local standard codes.
• The installation must conform to local codes, or in the absence of local codes, with the standard for the
storage and handling of liquid petroleum gases.
• A dented, rusted or damaged tank may be hazardous and should be checked by your tank supplier.
• Never use a tank with a damaged valve connection.
• The tank must be arranged to provide for vapor withdrawal from the operating cylinder.
• Never connect an unregulated tank to the heater.
BATTERY WARNINGS
•
Do not dismantle, open or shred batteries.
•
WARNING! Danger of explosion! Protect batteries against heat, e. g., against continuous intense
sunlight or fire, and against water and moisture! Also protect batteries from cold!
•
WARNING! Never charge non-rechargeable batteries!
•
Do not short-circuit the battery. Do not store batteries in a box or drawer where they may short-circuit each other or be short-circuited by other metal objects.
•
Do not remove batteries from their original packaging until required for use.
•
Do not subject batteries to mechanical shock.
•
Prevent battery acid from coming into contact with skin and eyes. If you do get battery acid in your eyes or mouth, flush them thoroughly with lots of water and
seek medical advice immediately. If battery acid comes into contact with your skin, wash the affected area with lots of water and soap.
•
Observe the polarity (+ and -) marked on the battery and appliance.
•
Keep batteries out of reach of children at all times.
•
Seek medical advice immediately if batteries have been swallowed.
•
Only use batteries recommended by the manufacturer for the appliance. Observe the technical data ( Technical data).
•
Keep batteries clean and dry.
•
Clean the contacts on the battery and the appliance prior to inserting.
•
Only use batteries in the application for which they were intended.
•
Remove the battery from the appliance when not in use.
•
Remove exhausted batteries promptly from the appliance. Dispose of batteries properly.
LEAKAGE TEST
• Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must be performed at the installation site due
to possible mishandling in shipment or excessive pressure being applied to the heater.
• Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied with a spray bottle, brush or rag. Soap bubbles will
appear in case of a leak.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the OFF position.
• Turn the gas supply ON.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on and re- check.
• Never leak test while smoking.
• Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result
in a fire or explosion, damage to property, serious bodily injury, or death.
• The device may not be used in the event of a leak. When the unit is turned on, shut off the gas supply and check the unit before using again.
• The recommended frequency of tubing or flexible tubing testing (at least once a month and each time the cylinder is replaced) and the need for regular replacement,
if indicated on the tubing or flexible tubing. If the hose shows signs of cracking or other damage, it must be replaced with a new hose of equal length and quality.
• A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced.
7
1
1.
2.
3.
4.
100 cm
GB
2
3
4
Seal
Hose
Regulator
Cylinder
100 cm
Publicidad
