OPERATING INSTRUCTIONS
REMOTE CONTROL
1. LED display: Shows the set temperature or the
auto-timer settings. Shows whether Follow Me is
active.
2. Temperature control buttons: Used to set the
temperature. Press and hold both temperature
control buttons for 3 seconds to change the
temperature display from °C to °F.
3. Mode button: Press to select the desired mode.
4. Power button: Press to turn on or off.
5. Fan button: Press to select fan speed.
6. Swing button: Press to start the auto swing
feature. When auto swing is activated, press
again to stop the louver at the desired angle.
7. Sleep button: Press to start the sleep feature.
8. Timer on button: Press to set the automatic on
timer.
9. Shortcut button: Press to set and activate the
Shortcut feature.
10. Timer off button: Press to set the automatic off
timer.
11. Follow Me button: Press to activate Follow Me.
12. LED button: Press to turn the LED display on or
off.
3
6
9
11
1
TEMP
2
4
5
8
7
10
12
REPLACING THE REMOTE BATTERIES
This air conditioner comes with two AAA batteries.
Place the batteries in the remote control before use.
1. Slide the back cover from the remote downward
to expose the battery compartment.
2. Insert the batteries, ensure to match the (+) and
(-) symbols on the ends of the batteries with the
symbols inside the battery compartment.
3. Slide the battery cover back into place.
Notes:
• The air conditioner will not respond if curtains
or other items block the signal from the remote
control to the air conditioner.
• If the infrared receiver on the control panel is
exposed to direct sunlight, the signal from the
remote might not be received properly. Use
curtains to prevent the sunlight from falling on
the receiver.
• Do not mix old and new batteries or batteries of
different types.
• Do not leave the batteries in the remote control
if it is not going to be used for more than 2
months.
Do not dispose of batteries as unsorted municipal
waste. Refer to local laws for proper disposal of
batteries.
14
IMPORTANT