Silvercrest SPPB 5000 A1 Instrucciones De Uso página 54

Using the power bank as a light
The power bank
♦ Place the lighting attachment
♦ Press the ON/OFF button
lighting attachment
NOTE
► The power consumption of the lighting attachment
150 mA. When using the lighting attachment
USB port
Troubleshooting
The power bank does not charge
♦ Cable connection faulty. Check the connection.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
♦ The charging current of the connected device is too low
(< 50 mA) or too high (> 2.1 A).
♦ The internal overcurrent protection has been triggered.
Disconnect the attached device and connect the micro-USB
charging port
section Charging the power bank).
Afterwards, the power bank can be used again.
SPPB 5000 A1
has a lighting attachment
on or off.
may only be loaded with maximum 1.95 A.
to a power source for a short while (see
.
on the power bank.
for approx. 3 seconds to switch
to start the charging process.
GB│MT
is
, the second
51■
│