Shindaiwa Speed-Feed 375 RH Instrucciones De Instalación

P/N 78890-19002
Installation and Loading Instructions
Package Contents:
1 Speed-Feed 375 RH Mount Trimmer Head w/Bushing 3/8-24 RH
®
1 Mounting Stud 3/8-24 RH X 8mm x 1.25mm
Trimmer Head Installation
1. Insert locking tool (A) into gear case to lock output shaft (B). Remove existing
cutting attachment (C) from unit following manufacturer's instructions.
IMPORTANT: Your unit must be equipped with a debris shield including a line
cutter that will cut line to length when trimmer line is advanced.
2. If required, install new mounting stud (D) into threaded hole in gear case output
shaft (B). Turn "RH" stud clockwise to tighten.
3. Attach New Trimmer Head (E)
Turn "RH" trimmer head clockwise on mounting stud to tighten. Hand-tighten only.
4. Remove locking tool (A) from gear case.
5. If necessary, cut trimmer lines so length does not extend beyond the cut-off blade
on debris shield.
WARNING
Read and understand the operator's manual that came with your unit.
Serious personal injury can result if you do not follow the manufactur-
er's installation and operation instructions.
Always wear proper foot, hearing, body protection and eye protec-
tion that conforms to ANSI Z87.1. Serious personal injury can occur if
proper attire is not worn.
Make sure all guards and adapters are properly installed on unit. Keep
bystanders 50 feet (15 meters) from operator. Injury to operators or by-
standers can occur from the rotating attachment or flying debris.
Shindaiwa operator's manuals are available from your Authorized
dealer, on the Internet at www.shindaiwa.com or by writing: ECHO
Incorporated, 400 Oakwood Rd., Lake Zurich, IL 60047.
X7672051200
04/11
Speed-Feed
®
375 RH Trimmer Heads
A
C
D
B
A
E