Technical Data - Surtek AT714 Manual De Usuario

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents and
may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrat-
ing oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy
plastic which may result in serious personal
injury.
Electric tools used on fiberglass material,
wallboard, spackling compounds, or plaster
are subject to accelerated wear and possible
premature failure because the fiberglass chips
and grindings are highly abrasive to bearings,
brushes, commutators,
we do not recommended using this tool for
extended work on these types of materials.
However, if you do work with any of these ma-
terials, it is extremely important to clean the
tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated
with a sufficient amount of high grade lu-
bricant for the life of the unit under normal
operating conditions. Therefore, no further
lubrication is required.
etc. Consequently,
E N G L I S H •

TECHNICAL DATA

VOLTAGE-FREQUENCY
SPEED
BIT HOLDER CAPACITY
POWER
POWER CONSUMPTION
WEIGHT
U se r ' s m an ua l
120 V ~ 60 Hz
(0 - 4 000) r/min
1/4" (6,3 mm)
710 W
0,3 kWh
1,3 kg (2,8 lb)
13