Descargar Imprimir esta página

Technical Specifications; Switching On And Off - Surtek AR436 Manual De Usuario

Atornillador recargable

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

driver to rotate in a clockwise direction, it will

go (for screwing in screws).

2. Push the "Reverse Direction" rotational di-

rection switch to the stop, to cause the screw-

driver to rotate in a anti-clockwise direction, it

will go (for loosening or unscrewing screws).

CAUTION: Before use, check the direction

of the rotation. Change direction of rotation

only when machine is not in operation.

SWITCHING ON AND OFF

To start the machine, press the On/Off switch

and keep it depressed. To switch off the ma-

chine, release the On/Off switch.

NOTE: With the rotational direction switch in

the middle position, the On/Off switch will not

be active and the spindle will be locked. Use

the tool in this made as any conventional non-

powered screwdriver.

FULLY AUTOMATIC SPINDLE LOCKING

(AUTO-LOCK)

The drill spindle is locked when the On/Off

switch is not pressed. This enables screws to

be screwed in, even when the battery is emp-

ty and allows for the product to be used as a

screwdriver.

Switching for LED Light

Press switch to turn on the screwdrivert. Re-

lease switch to turn off the LED light.

Battery Indicator

Before use, please check the battery by oper-

ating the tool (unloaded). Three status lights

show the charge status of the battery:

· Red, yellow and green all light: Battery fully

charged.

· Red and yellow light: Battery at half charge.

· Red light: Battery almost discharged.

NOTE: Never use the tools when charging the

battery.

MAINTENANCE

Environmental Protection

To remove the battery from the machine, actu-

ate the On/Off switch until the battery is fully

discharged. Unscrew the screws on the casing

and take off the casing shell. Disconnect the

connections at the battery and take out the

battery.

E N G L I S H •