Before Use; Fitting The Battery; Charging The Battery - Hilti SFC 14-A Manual De Instrucciones

6. Before use

6.1 Battery use and care
en
NOTE
Battery performance drops at low temperatures. Use
a battery only when it has been fully charged. This
ensures that maximum battery capacity is available.
Change to the second battery as soon as a drop in
performance is noticed. Recharge the battery imme-
diately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store
the battery where it is exposed to direct sunlight or
sources of heat, e.g. on heaters / radiators or behind a
motor vehicle windscreen. Batteries that have reached
the end of their life must be disposed of safely and
correctly to avoid environmental pollution.

6.2 Charging the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first
time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
Read the operating instructions for the charger for
further information about the charging procedure.
22
Printed: 07.07.2013 | Doc-Nr: PUB / 5070682 / 000 / 00
Li-ion batteries are ready for use at any time, even
when only partly charged. Charging progress is in-
dicated by the LED display (see charger operating
instructions).

6.3 Fitting the battery

CAUTION
Before fitting the battery, check that the power tool
is switched off and that the safety lock is engaged
(forward/reverse switch in the middle position). Use
only the Hilti batteries approved for use with this
power tool.
CAUTION
Check that the terminals on the battery and in the
power tool are free from foreign objects before
inserting the battery in the power tool.
1. Push the battery into the power tool from the
rear as far as it will go and until it is heard to
engage with a double click.
2. CAUTIONA falling battery may present a risk of
injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery 2
1. Press the release button.
2. Pull the battery out of the power tool toward the
rear.
6.5 Belt hook 3
CAUTION
Check that the belt hook is fitted securely before
beginning work.
The belt hook allows the power tool to be attached to
a belt worn by the operator. The belt hook can also
be fitted to the other side of the power tool for use by
left-handed persons.
1. Pull the battery out of the tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.