Description - Hilti SFC 14-A Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Volts
operating
instructions
before use
Revolutions Drilling
per minute without
hammering

2. Description

2.1 Use of the product as directed
The SFC 14-A is a hand-held, cordless drill / driver for driving and removing screws and for drilling in steel,
wood and plastic.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Do not use the battery as a power source for other unspecified appliances.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
2.2 Chuck
Keyless chuck
16
Printed: 07.07.2013 | Doc-Nr: PUB / 5070682 / 000 / 00
Wear ear
hat protection
Direct current
Return waste
material for
recycling.
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate at the base of the power tool and
the serial number on the side of the casing. Make a
note of this data in your operating instructions and
Wear
always refer to it when making an enquiry to your
protective
Hilti representative or service department.
gloves
Type:
Generation: 01
Serial no.:
Rated speed
under no load