Publicidad
drawing 2
case
Rotor
drawing 3
3063143_0911
Installation of the rotor
Installation of the rotor
Slide on the first rotor section onto the fixed spokes and and secure it with the alu-
minium prism (pos. 4 – drawing 2) to the spoke (pos. 3 – drawing 1). Afterwards,
secure the section with the outside sealing sheet (pos. 5 – drawing 2).
insertion direction
Assemble the remaining sections accordingly. Please note the direction of rotation
according to drwaing 2. Insert every outside sealing sheet (pos. 5 – drawing 2), con-
sidering the separated drillings, under the anterior outside sealing sheet and secure
with the locking screws (pos B – drawing 2). Contract sections reciprocal.
fixation of
storagemass
After the installation of all sections, retighten the locking screws (pos. B – drawing 2)
again firmly.
Assemble the rotor bearing covers (pos. 6 – drawing 2) to the spokes (pos. 3 – dra-
wing 1) with the attached fixing material.
Final installation workings
Fix the sealing lips with the fixing springs (pos. 7 – drawing 3) and the metal strips
(pos. 8 – drawing 3) in direction to the rotor area.
Conduct the sealing correspondingly with the sealing lips through the whole length.
After having finished the workings, install centre cover (pos. 9 – drawing 3).
After having finished the workings, connect rotor and motor with the driving belt (open
v-belt with locking element) and mount outside casing cover panels.
Carry out test run, rotor must not touch the casing, sealing have to fit tightly.
7
Publicidad
