Leatt 3.5 NECK BRACE Manual Del Usuario página 3

Brace Setup
Please follow the steps to fit your 3.5 neck brace
1
a.
Before you put on your 3.5 neck brace, fit the thoracic (not attached) on the rear of the brace. Line up
the thoracic with the two slots on the rear. Use the two red pins (supplied) to secure thoracic in chosen
position on the brace.
2
a.
Open the brace by pushing the red release 'open' button situated on the front left hand side of the brace.
The brace will then unlock and open at the front.
3
a.
Fit the brace with the rear thoracic facing your back (3a). Close the brace (3b)
®
Copyright © 2021, Leatt Corporation
b.
b.
c.
b.
b.
GB
3