Publicidad
Idiomas disponibles
Idiomas disponibles
EN INSTRUCTIONS ON ASSEMBLY AND USE
CONGRATULATIONS ON
PURCHASING THIS PRODUCT!
Please read these instructions carefully. The instructions are an integral
component of the product. Therefore, please store them and the packa-
ging carefully in case questions arise in the future. Please always include
these instructions when handing on the product to a third party. This pro-
duct must be assembled by an adult. This product is designed for private /
domestic use only. This product is not designed for commercial / indus-
trial use. The use of the product requires certain capabilities and skills.
Always adjust according to the age of the user and use for the purpose it
has been designed for.
TECHNICAL SPECIFICATIONS
Item:
Nest Swing 90
Item number:
72126/01
Maximum carrying capacity: 100 kg
Dimension:
90 cm ø
Purpose:
Device powered by muscle power, for swin-
ging in a sitting or lying position.
Minimum user age:
36 months
If you have assembly problems or would like further information on the
product, we have all you need and more at http://www.hudora.de/.
CONTENTS
1 x Nest swing (cf. parts list on page 2) | 1 x These instructions
Other parts which may be included with the delivery in some circum-
stances are not required.
SAFETY INSTRUCTION
• WARNING! Maximum load cannot exceed 100 kg.
• WARNING! Minimum user age: 36 months.
• WARNING! Only for domestic use.
• WARNING! To be used under the direct supervision of an adult.
• WARNING! Not suitable for children under 36 months. Danger of falling!
• WARNING! Not suitable for children under 36 months. Long cord. Stran-
gulation hazard.
• WARNING! Suitable for outdoor and indoor use!
• The owners of the swing as well as the competent supervisory person-
nel are responsible for ensuring that all users follow the instructions in
the operation manual.
• Do not make any technical modifications.
• Changes to the original product must only be carried out according to
manufacturer specifications.
• No one is permitted to gain access to the swing area during use.
• Never stand or kneel on the swing.
• Always hold yourself firmly with both hands.
• No objects of any kind must be in the vicinity of the swing zone (trees,
walls, fences, clotheslines).
• Make sure that you have a safety clearance of at least 2 m (front and
back) beyond the maximum reach of the swing and make sure the
ground is level and shock absorbing (e.g. grass) without any sharp
edges or pointed objects, obstacles, inclines, levels, steps or hard sur-
faces (e.g. concrete) etc.
• Clearance to stationary components on the side, such as the swing
scaffolding must be at least 40 cm.
• Swinging components, such as a neighboring swing must be placed at
a distance of at least 60 cm.
• Maximum raised height must not exceed 2.5 meter as measured from
the ground.
• In idle mode, the swing must be at least 40 cm and maximally 60 cm
from the ground.
• You should never install a swing in such a way that the user could be
blinded by sun rays.
• The self-locking effect of the self-locking nuts or else lacquer can
subside after repeated loosening and tightening of the connection ele-
ments.
• When permanently irradiated with UV light, the material ages signifi-
cantly faster. To avoid premature aging and thereby extend the service
life, you should always store the product in a dry and dark place when
not in use. Do not permanently expose the product to wind, moisture,
extreme temperatures or sunlight.
All images are examples of the design.
UKAR Contact: UKCA Experts Ltd. | Dept 302, 43 Owston Road |
Carcroft, Doncaster, DN6 8DA | United Kingdom
INSTRUCTIONS ON ASSEMBLY
Prior to installation, carefully select and check the location where you will
install the swing. Please make sure that the swing carrier is adequately
stable. Please also take into account that swinging produces centrifugal
forces that can put a lot of strain on the swing carrier. Please consult an
expert (statics expert, architect, carpenter) and ask how much load your
swing carrier can tolerate.Suspension connectors shall be of a design that
will prevent unintentional disconnection.Remove the parts from the pa-
ckaging and check that they are complete. Check that parts 2, 3, 4 and 7
are already assembled as in fig. A. Now spread the nest (5) on the ground.
Insert part of the foam-covered tube frame (1) into each of the four side
loops (fig. B), then insert the parts into one another. Ensure that one nar-
row and one wide tube end is put together in each case. Feed the screw
hooks (2) from above into the tubular frame and tighten the nuts firmly
(simplified illustration in fig. C. See also safety notes!) In order to provide
for a firm and secure fit of the nut screw, please screw at least the entire
height of the nut on the screw hooks (2). The torque for tightening the nut
should be between 8 and 10 Nm. You can now hang the nest swing from a
suitable swing frame using the retaining rings (3).
HANGING DEVICE AND ADJUSTMENT
The hanging points must be at least as far apart as the swing seat
+ 100mm. The swing is packaged with two ropes and adjustment eyelets
(4), so that the height of the swing can be variably aligned with any sui-
table hanging device. The swing rope (7) can be lengthened or shortened
by pushing or pulling it through the adjustment loops (4). The hanging
swing can now be individually adjusted. No one should sit on the swing
while making the adjustments. When extending or reducing the length of
the swing ropes please make sure that the ropes remain equally long at all
times. If the lengths of the ropes differ, this will lead to circular pendulum
movements of the swing. Make sure that swing is set up in such a way that
the person using the swing cannot reach the ground with the tips of his or
her toes. If in doubt, perform a few gentle test swings.
MAINTENANCE AND STORAGE
Use a dry or damp cloth only to clean the product; do not use special clea-
ning agents! Check the product for damage or traces of wear and tear be-
fore and after each use. Do not make any structural changes. For your own
safety, please use original spare parts only. These can be sourced from
HUDORA. If parts become damaged or if sharp edges or corners should
develop, the product may not be used any more. If in any doubt, please
contact our service team (http://www.hudora.de/). Store the product in a
safe place where it is protected from the elements, cannot be damaged,
and cannot injure anyone.
You should also replace all the plastic parts after a maximum of 5 years to
prevent a possible failure of these parts.
Check the product for damage or traces of wear and tear before and after
each use. We also recommend before each use:
• to check for the firm sitting of nuts and bolts, tighten if necessary
• to lubricate moving parts in order to minimize wear
• to check all covers of screws and sharp edges and replace if necessary
• to replace defective parts according to the manufacturer's instructions
• to check swing seats, chains, ropes and other means of attachments for
evidence of deterioration
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate coll-
ection point in your area. Local waste management companies will be able
to answer your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise ho-
wever, we put just as much effort into rectifying them. You can find nu-
merous information on the product, replacement parts, solutions to pro-
blems and lost assembly manuals at http://www.hudora.de/.
4/12
Publicidad
