LEGRAND C2G31013 Manual Del Usuario página 5

HDMI® HDBaseT + 3.5mm, USB-B to A, and RS232 over Cat Extender
Box Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
① ② ③ ④
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
Set the function of RS232 port.
PASS-THROUGH (Default): RS232 port is used to RS232
commands pass-through over HDBT.
5 RS232 DIP Switch
MCU: RS232 port is used to update its MCU firmware.
VS: RS232 port is used to update Valens firmware of transmitter
and receiver.
Receiver
⑤
Rear Panel
⑥
⑦
R P D
EAR ANEL ESCRIPTION
Connect to the provided DC 12V power adapter. With PoH function,
6 DC 12V one power adapter is needed to connect to the receiver to power both
units.
7 HDBT IN Connect to HDBT OUT port of transmitter
8 RS232 For RS232 pass-through.
9 HDMI OUT Connect to an HDMI display using an HDMI cable.
Unbalanced stereo audio output.
PASS THROUGH: For audio pass-through from Audio IN port
•
AUDIO OUT
10
on the transmitter to this port.
DE-EMBED: For audio de-embedding from the HDMI output.
•
Connect to USB devices such as keyboard, mouse, USB camera, etc.
Note: USB ports support USB 2.0 standards with a maximum of 1.4A
11 4x USB-A
for the top two ports and 0.6A on the bottom two ports. USB cameras
are recommended to be connected into one of the top two 1.4A ports.
3
Receiver
⑨ ⑩ ⑪
⑧
(us)
(us)