LEGRAND C2G31013 Manual Del Usuario página 7

HDMI® HDBaseT + 3.5mm, USB-B to A, and RS232 over Cat Extender
Box Transmitter to Box Receiver - 4K 60Hz
RS232 Pass-through
RS232 port can be used for bi-directional RS232 signal pass-through between the transmitter and receiver.
Steps to set up for RS232 pass-through:
1. Set the DIP switch of the receiver to the position of "PASS-THROUGH".
2. Connect a RS232 Master (or Slave) Device to RS232 port of the transmitter with a RS232 cable.
3. Connect a RS232 Slave (or Master) Device to RS232 port of the receiver with a RS232 cable.
4. Connect HDBT OUT of the transmitter to HDBT IN of the receiver with a Cat 5e/6/6a/7 cable.
When all is set, RS232 signal can be passed through bi-directionally between two RS232 devices.
Upgrade
The receiver supports firmware upgrading through RS232 port. Please contact your supplier to get the latest upgrade tool,
"Legrand Product Firmware Updater."
Steps to upgrade FW:
1. Set the receiver's DIP switch to the position of "MCU."
2. Connect the device to a PC using a USB Type-A to 3-pin phoenix connector cable.
3. Connect the power adapter provided to the receiver. Then power on all of the attached devices.
4. Open the "Legrand Product Firmware Updater" software. The interface of the software is as follows on page 6.
(Step 5 continued on page 7)
5
(us)
(us)