Pioneer SC-LX56 Guia De Inicio Rapido página 3

Connecting up
Connecting the speakers
The receiver will work with just two stereo speakers (the front speakers in the diagram) but using
at least five speakers is recommended, and a complete setup is best for surround sound.
To achieve the comfortable surround sound, install your speakers as shown below.
7.2 channel surorund system:
R
L
SW 1
SR
C
SW 2
SBR
SL
SBL
Connecting the speaker cables
Make sure you connect the speaker on
the right to the right (R) terminal and the
speaker on the left to the left (L) terminal.
Also make sure the positive and negative
(+/–) terminals on the receiver match those
on the speakers.
1
Twist exposed wire strands together.
2
Loosen terminal and insert exposed
wire.
3
Tighten terminal.
1 2 3
10 mm
L – Front Left
C – Center
R – Front Right
SL – Surround Left
SR – Surround Right
SBL – Surround back Left
SBR – Surround back Right
SW – Subwoofer
CAUTION
• Before making or changing connections,
switch off the power and disconnect the
power cord from the AC outlet.
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent the
risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before
touching any uninsulated parts.
After installing the speakers, connect them as shown below.
Center
Front Right Subwoofer 1
(R) (SW)
LINE LEVEL
INPUT
FRONT SUBWOOFER
1
CENTER
A
FRONT CENTER FRONT HEIGHT
R L R
SPEAKERS
Surround Right
(SR)
Surround back Right
(SBR)
Note
• If you have two subwoofers, the second subwoofer can be connected to the SUBWOOFER 2
terminal. Connecting two subwoofers increases the bass sound to achieve more powerful
sound reproduction. In this case, the same sound is output from the two subwoofers.
• This unit supports speakers with a nominal impedance of 4 W to 16 W.
Subwoofer 2 Front Left
(C)
(SW) (L)
LINE LEVEL
INPUT
SURROUND SURR BACK F HEIGHT F WIDE
2
(Single)
L
R
PRE OUT
B
FRONT WIDE / SURROUND
L R L R L R
Surround Left
(SL)
Surround back Left
(SBL)
A
SURROUND BACK
L
(Single)
3