Naterial NORI 2 LED Instrucciones De Montaje, Utilización Y Mantenimiento página 90

FR
Replace all used batteries with the same type only.
Attention! Danger of explosion! Never insert batteries inversely.
ES
If batteries should leak, remove them with a cloth from the battery compartment.
Dispose of batteries according to the regulations. If battery acid has leaked avoid contact to
PT
acid and wash with plenty of clean water. Visit a physician.
I T
Swallowed batteries are lethal. Keep batteries out of reach of children and pets. Immediately
ask for medical assistance if a battery is swallowed.
EL
Remove exhausted batteries from the remote control. Remove the batteries from the remote
PL
control, if you will not use it for an extended period of time.
UA
CR2450, 3V
RO
EN
The motor will automatically go into overheat-protection mode after two
7. ADJUSTMENT WHEN CHANGING THE REMOTE
CONTROL
blue electric cords of motor to the power interface (Or with electric cord of motor plugged in a
Step 2: Take out the controller and keep the battery in place, the inductor light will be on. If not
in place, the inductor light will not be on. No need to cover the battery lid before well-coding.
Step 3: Keep ear close to the head of motor and then turn on the power under a quite
time, you will hear a clear but small and short sound «Di». This shows it work well. If without
X1 Changing batteries
Overheat protection:
consecutive extending (down) and retracting (up) operations
2014/53/EU-2014/30/EU-2014/35/EU-2006/42/EC
Conform to:
90