Publicidad
Idiomas disponibles
Idiomas disponibles
4.4.2
Modifying the room set-point
Pressing the
[
and
]
set-point modification mode.
The set-point is varied in 0,5°C steps, within a range from 5°C
to 30°C.
The new set-point must be confirmed by pressing the
The current set-point s restored if the
the system remains inactive for 8 sec.
4.4.3
TEMPORARY MANUAL mode
The TEMPORARY MANUAL mode can only be activated from the
AUTOMATIC mode. It consists in a MANUAL mode with expiry
corresponding to the current time slot. Basically it is a tempo-
rary variation of the set-point of the current time band.
To activate this mode, press the
sired temporary set-point and press the
set-point.
1 2 3 4 5 6 7
30
keys allows for switching to the room
P
key is pressed or if
[
and
]
keys to set the de-
@
key to confirm the
C°
C°
H
M
The main screen will return, and any modifications will not be
applied, if the
P
for 8 sec.
At the end of the time slot, the zone will return to AUTOMATIC
mode.
The mode can be modified by following the instructions of the
@
key.
previous paragraph.
4.4.4
Stand-by mode
The device will enter the "Stand-by" mode 8 sec. after the last
key was pressed, and the LCD will switch off.
To reactivate the display, press any key on the main screen for
roughly 1 sec. The first press switches the display on and only
the next press will perform the desired action.
4.4.5
Anomaly visualisation
If there is a system anomaly, when the display is reactivated
from the Stand-by mode, the relative error code will be dis-
played for 5 sec. and "ERR" will appear in the small digits.
After 5 sec., the display will return to its normal operating
mode.
key is pressed or the system remains inactive
1 2 3 4 5 6 7
C°
C°
H
M
EN
Publicidad
