Publicidad
Idiomas disponibles
Idiomas disponibles
diameter washers must be installed by the slots. Adjust handlebar height with its fixing screws (3). Position the gear lever (4) putting though its guide
(5) and push the tip into the hole on the swivel (6) and clamp it with safety pin (7).
EN
HOW TO MOUNT THE ACCELERATOR WIRE (provided with metal sheath) Fig. 3
Position the lever (fig. 3, item 1) on the engine at the end of its stroke as shown by arrow "A " in the figure. Move the throttle lever(2) on the handlebar
to the end of its stroke as shown by arrow "B " in the figure. Insert wire (3) into hole (4), secure the sheath (5) with retainer (6) and screw (7). The
throttle wire must be fixed to the engine at the sparkplug side. ATTENTION: in the position "stop" the throttle lever must stop engine.
BELT STRETCHER DRIVING WIRE (Fig. 4)
The driving cable (1) is already linked to the belt stretcher lever of the frame to the lever (2).
Please tighten the lever (2) on the handlebar using the screw (3) you can find into the loose parts bag.
ATTACHMENTS ASSEMBLY (Fig. 6)
The cultivator has a quick couple for attachments. Assemble the belt on the upper pulley A with the
following attachments : grassland mower, brush and rotavator. Assemble the belt on the lower pulley B with the cutting bar.
ATTACHING THE MOWER BAR (Fig. 6a)
The cultivator has a quick couple for attachments. The motor should be shut down and the
machine horizontal. Insert the cutter bar pin (1) halfway into its seating (2). Install the belt (3) in its pulley by moving the guide pin all the way to the
end of its travel. Position 1 and 2 : turn the handle (13) until you are able to couple the spring (14) to the connection (15) .
Position 2 and 3 : to complete the above coupling , rotate the handle (13) in the opposite direction until you are able to tension the spring (14).
Replace the cowling (6) with its centering pin (7) and the threaded pin (8). Tighten home the nut with its washer on the cowling.
ATTACHING THE CULTIVATOR (Fig. 6b)
The cultivator has a quick couple for attachments. The engine must be switched off and the
machine on level ground. Insert the cultivator pin (1) halfway into its seating (2). Install the belt (3) in the appropriate pulley and push the pin (1) all
the way in. Position 1 and 2 : turn the handle (13) until you are able to couple the spring (14) into the slot (15) .
Position 2 and 3 : to complete the above coupling , rotate the handle (13) in the opposite direction until you are able to tension the spring (14).
Install the cover (6) using its centering screw (7). The reverse gear blocking lever (8) will be correctly positioned with the gear lever (9). Tighten home
the nut and its washer to fix the cover (6)
REVERSING ROD ASSEMBLING (Fig. 2)
Connect the extremity of the rod (9) in the hole of the lever (10), so lock with the R-shape pin.
ATTACHMENT DRIVE BELT REGISTRATION (Fig. 7)
To increase belt tensioning between machine and attachment, use the register
(2) so that the attachment begins to work only when the control lever has been moved more than halfway its travel (Fig. 7)
If a mower is attached, to increase the tension on the two bottom mower drive belts, slacken off nut (9) and remove the washers between the
half-pulleys (Fig. 6a).
If a cultivator is attached, check belt tension after two work hours (3, Fig. 6b).
20
HOW TO OPERATE THE DRIVE OF THE CUTTING BLADE (Fig. 7):
disconnect the safety lever (3), then push down the lever
for the tool insert (4).
Publicidad
