Husqvarna 967262701 Manual Del Operador página 29

LUBRICATION
Wheel and Deck Zerks
Front Wheel Mount
set of wheel mounts.
Front Wheel Bearings
set of wheel bearings.
Deck Spindles
If a grease gun without rubber hose is used, the
foot plate must be removed to access the center
spindle.
spindle.
Engine oil change
NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
recommendations.
WARNING
so the engine is still warm but the surrounding
surfaces and oil are not.
1.
2. Clean the dirt and debris from the area around
3.
4. Locate the drain hose at the left rear of the
under the end of the drain hose and remove
the oil drain plug.
5.
6.
7. Fill the engine with new oil to the bottom of
8.
level is FULL.
9.
and changing intervals.
29