Makita DTR180 Manual De Instrucciones página 2

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Tie wire (Optional accessory)
Diameter of rebars that can be tied
Approximate number of ties
per reel
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Combination of rebars that can be tied
Combination of 2 rebars
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 3 rebars
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 4 rebars
#3 x #3 (10 mm x 10 mm)
#4 x #4 (13 mm x 13 mm)
NOTICE:
If there is a gap between rebars or if the tool is used at an incorrect orientation, the rebars may not be
able to be tied.
Annealing iron tie wire
Galvanized tie wire
Poly coated tie wire
D.C.14.4 V Model
D.C.18 V Model
From #3 x #3 to (#4 x 2) x (#4 x 2)
From 10 mm x 10 mm to (13 mm x 2) x (13 mm x 2)
Approximately 120 ties
Approximately 120 ties
Approximately 105 ties
2.3 - 2.6 kg (5.1 - 5.7 lbs)
BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF / DC18SH
#3 (10 mm)
#3 x #3 (10 mm x 10 mm)
#3 x #3 (10 mm x 10 mm)
2 ENGLISH
DTR180
ø0.8 mm (21GA)
304 mm (12")
D.C. 14.4/18 V
BL1430B
#4 (13 mm) #5 (16 mm)
#4 x #4 (13 mm x 13 mm)
-
#4 x #4 (13 mm x 13 mm)