Descargar Imprimir esta página

Scheppach HS115 Traduccion Del Manual De Instrucciones Originale página 42

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 121
Noise
The noise values have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
m WARNING
Excessive and frequent exposure to noise can lead to
hearing damage or hearing loss.
-
Wear hearing protection
-
Take breaks.
Total vibration values (vector sum of three directions)
determined according to EN 62841.
NOTE: The specified device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one elec-
tric tool with another.
The specified noise emission values can also be used
for an initial estimation of the exposure.
WARNING: The noise emission values can vary from
the specified values during the actual use of the elec-
tric tool, depending on the type and the manner in
which the electric tool is used, and in particular the type
of workpiece being processed.
Implement measures to protect against noise nuisance.
In doing so, take into account the complete working
process, including the times when the power tool is
working without load or switched off.
Suitable measures include regular maintenance and
care of the power tool and the insertion tools, regular
breaks as well as proper planning of the working pro-
cess.
It is necessary to define safety measures to protect the
operator which are based on an estimate of vibration
exposure during the actual operating conditions (for
this, all parts of the operating cycle have to be consid-
ered, e.g. times during which the power tool is switched
off and times during which it is switched on but runs in
no-load mode).
42 | GB
8. Unpacking
m DANGER
Danger of choking or suffocating
The packaging material, packaging and transport safe-
94 dB(A)
ty devices are not children's toys. Plastic bags, foils
3 dB
and small parts can be swallowed and lead to choking.
107 dB(A)
-
Keep packaging material, packaging and trans-
port safety devices away from children.
3 dB
• Open the packaging and carefully remove the product.
• Remove the packaging material, packaging and
transport safety devices (if applicable).
• Check the completeness of the scope of delivery.
The customer service must be notified immediately
of any complaints. Later claims will not be recog-
nised.
• Check the scope of delivery for transport damage.
The transport company must be notified immediate-
ly of any complaints. Later claims will not be recog-
nised.
• Keep the packaging until the end of the warranty
period.
• Read through the operating manual completely.
• Only use original spare parts or accessories. Origi-
nal spare parts or accessories can be obtained from
your dealer.
• Check that the data on the type plate matches with
the mains power data.
9.
Assembly
m WARNING: Remove the mains plug before any
maintenance, modification or assembly work on the
circular table saw.
m Attention!
Always make sure the device is fully assembled
before commissioning!
You require the following for assembly:
1x ring spanner, 10/13 mm (26)
1x ring spanner 10/21 mm (27)
(included in the scope of delivery)
1x Phillips screwdriver
1x Allen key 5 mm
(not included in the scope of delivery)
• Place all supplied parts on a flat surface.
• Group equal parts.
www.scheppach.com

Publicidad

loading

Este manual también es adecuado para:

59013209942