Publicidad
Idiomas disponibles
Idiomas disponibles
16. Storage
m WARNING
Danger of injury due to unexpected start-up of the ma-
chine
-
Remove the mains plug from the socket.
ATTENTION
Product damage due to incorrect storage
-
Store the product protected against dirt, dust and
moisture.
-
Store the product in its original packaging.
1.
Store the product in a dark, dry and frost-free
place that is inaccessible to unauthorised persons.
2.
The optimum storage temperature lies between 5
and 30 °C.
3.
Store the operating manual with the product.
17. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the extension
cables used must also comply with these regula-
tions.
• The product fulfils the requirements of
EN 61000-3-11 and may only be used at the follow-
ing connection points: This means that use of the
product at any freely selectable connection points
is not allowed.
• Given unfavourable conditions in the power supply
the product can cause the voltage to fluctuate tem-
porarily.
• The product is intended solely for use at connection
points that
a. do not exceed a maximum permissible mains im-
pedance "Z" (Zmax = 0.345 Ω), or
b. have a continuous current-carrying capacity of
the mains of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion with your electric power company if necessary,
that the connection point at which you wish to oper-
ate the product meets one of the two requirements,
a) or b), named above.
Important information
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor
can be switched back on again.
17.1 Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors
• Kinks where the connection cable has been improp-
erly fastened or routed
• Places where the connection cables have been cut
due to being driven over
• Insulation damage due to being ripped out of the wall
outlet
• Cracks due to the insulation ageing
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
If the power cord of this device is damaged, it must be
replaced by the manufacturer, their service department
or a similarly qualified person to avoid dangers.
17.2 AC motor
• The mains voltage must be 220−240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
• Extension cables over 25 m long must have a
cross-section of 2.5 mm
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate
www.scheppach.com
.
2
.
2
GB | 51
Publicidad
