Operation Of The Remote Control; General Rules; Initial Settings; Adjusting The Time - MCZ ACTIVE Manual De Uso

3 Operation of the remote control

3.1 General rules

The product is switched on and off by pressing button A for 1 second.
All modifications are made using button C. Button E is used to confirm
these modifications. Press button B to select the operating mode of the
product (see paragraph 3.3). Use button D to navigate the FAN and
SLEEP setting (see paragraph 3.4).
With the remote control in any status, briefly pressing button A (or not
touching the keypad for 7 seconds) will return you to the basic display.

3.2 Initial settings:

3.2.1 Adjusting the time:

With the remote control either off or on, pressing buttons B + E for 3
seconds will access the time/ day adjustment setting. The hour figures
will begin to flash and can be modified using button C. Pressing button
E confirms all modifications. The minute figures will then begin to flash.
Follow the same modify/ confirm procedure to move on to the time
display mode (12 h or 24 h) and, lastly, the day will begin to flash.
Confirming this data as well will exit the settings modification.
NOTE: each time the power is reconnected to the remote
control the time will zero and the display will automatically
enter the hour setting.
3.2.2 °C – °F setting.
Press button B for 5 seconds to change the unit of temperature
measurement from Celsius to Fahrenheit and vice versa. Do this only
while the stove is switched off.

3.3 Setting the operating mode:

While the remote control is switched on, button B allows you to set one
the four following operating modes of the product. Figures 1, 2, 3 and 4
show the four basic displays, respectively:

3.3.1 MANUAL mode (indicated by MAN):

In this mode you can manually set the power of the flame (5 levels -
use button C to directly modify) and the ventilation (5 levels + auto)
(see paragraph 3.4.1). Figure 1

3.3.2 AUTOMATIC mode (indicated by AUTO):

In this mode you can set the desired room temperature and the stove
will automatically modulate the power of the flame to reach this
temperature. The ventilation can be adjusted to 5 levels + auto (see
paragraph 3.4.1). Figure 2
Operation of the remote control
ACTIVE REMOTE CONTROL
USE MANUAL
Technical dept. - All rights reserved - Reproduction prohibited
Chapter 3
TU
12:02
31
°C
MAX
FIG.1
TU
12:03
31
°C
35
AUTO
FIG.2
5
page
MAN
°C