Timer Mode (Indicated By Timer); Eco Mode (Indicated By Eco ) - MCZ ACTIVE Manual De Uso

3.3.3 TIMER mode (indicated by TIMER):

When you select this operating mode you can switch the product on
and off automatically according to 6 customisable time frames (P1 –
P6). In each time frame you can set:
 The start-up time
 The shut-down time
 The desired room temperature in that time frame
 The days of the week in which the time frame is active
When the stove is started up (manually using button A or automatically
using a time frame) the product operates in the automatic mode
described above. When a time frame is enabled it is automatically
displayed (P1 in figure 3) and the desired temperature modifies to the
value set in the time frame. The user can modify this value at any time,
in real time, as desired.
To learn how to set the time frames refer to paragraph 3.5.

3.3.4 ECO mode (indicated by ECO ):

This mode enables/ disables when the remote control is switched on by
pressing button B for 5 seconds.
ECO mode is an automatic mode with the only difference that if the
temperature set is reached and maintained for the following 20 minutes
(regardless of the flame modulation) the product shuts down and
remains on stand-by until the room temperature drops 2 degrees below
the desired temperature (or until 5 minutes after the last shut down).
At this point the product restarts. Figure 4
If the room is not sufficiently insulated the flame modulation does not
allow the set temperature to remain satisfied for 20 consecutive
minutes and the product therefore does not shut down.
NOTE: We recommend that you use ECO mode only in well-
insulated rooms to prevent the appliance from starting up and
shutting down too frequently.
The remote control remains switched on, even while the product is
switched off due to ECO mode, to indicate that this shut down is only
temporary. Shutting down the product using button A exits ECO mode
and the product remains switched off.
In ECO mode you can also enable up to 6 automatic start-up/ shut
down time frames (E1 – E6). These are separate from those in the
TIMER mode (P1 – P6). If these time frames have been enabled the
message TIMER-ECO appears (figure 5) and is shown permanently
even when the remote control is switched off.
To learn how to set the time frames refer to paragraph 3.5.
NOTE: If the remote control shuts down by the TIMER, ECO
mode cannot restart until the user intervenes (button A) or
the next valid time frame is started. The use the TIMER
combined with ECO mode requires good knowledge of the
operating logic of the product.
Operation of the remote control
ACTIVE REMOTE CONTROL
USE MANUAL
Technical dept. - All rights reserved - Reproduction prohibited
Chapter 3
FR
P1
8:20
26
°C 20
FIG.3
TU
12:06
31
°C
23
FIG.4
TU
12:07
31
°C
23
FIG.5
6
page
°C
TIMER
°C
ECO
°C
TIMER
ECO