Optika Italy H Serie Manual De Instrucciones página 8

9. Connect the PC with the WLAN AP point that the camera provides.
• The network name (SSID) and the WLAN password (default one is 12345678) can be found on the camera's Setting>-
Network>WLAN page in AP mode.
10. Start ProView / LiteView software and check the configuration. Normally, active cameras are automatically recognized.
The live image of each camera is displayed.
11. For the display, the Camera List tool window is used in the ProView/LiteView software.
7.1.4 LAN Ethernet Mode
This application uses the camera as the network camera. User must conFig. the IP of the camera and PC manually and
ensure their IP addresses are in the same net. The subnet mask and gateway of the camera and PC must be the same.
1. Plug the HDMI cable into the HDMI port
2. Plug the USB mouse into USB Mouse port
3. Plug 12V/1A power adapter into DC 12V slot
⑧
• The LED Indicator
4. Press ON/OFF Button
• The LED indicator will turn into blue.
5. Move the mouse to the bottom of the UI and clicking the
video window. A small window called Settings will pop up as shown below.
6. Click the LAN property page, uncheck the DHCP item. Input the IP Address, Subnet Mask and Default Gateway for the
camera.
7. Designate the Internet Protocol Version 4 (TCP/IPv4) Settings page's IP address on the PC with similar configuration
as shown below but with different IP address.
④
to connect the C-HUB4K camera to HDMI display.
①
⑨
will turn into red.
⑦
to turn on the camera.
Fig. 3 - Camera IP configuration Page
Fig. 4 - PC'S IP configuration Page
to get control of the camera by using built-in software HDMIPRO.
to supply power for the camera.
button on the Camera Control Toolbar at the bottom of the
Page 8