LG LAN090HYV1 Manual Del Propietário página 10

BEFORE USE
10
Inserting batteries
Insert AAA (1.5 V) batteries before using the
remote control.
1
Remove the battery cover.
2
Insert the new batteries and make sure
that the + and - terminals of the batteries
are installed correctly.
3
Reattach the battery cover.
!
NOTE
• If the display screen of the remote con-
trol starts to fade, replace the batteries.
Installing the remote control holder
Install the holder where there is no direct sun-
light to protect the remote control.
1
Choose a safe and easily-accessible place.
2
Fix the holder by fastening the 2 screws
firmly with a screwdriver.
3
Slide the remote control into the holder.
Operating method
Point the remote control towards the signal
receiver at the bottom of the air conditioner to
operate it.
!
NOTE
• The remote control may operate other
electronic devices if pointed towards
them. Make sure to point the remote
control towards the signal receiver of
the air conditioner.
• For proper operation, use a soft cloth to
clean the signal transmitter and receiver.
• Jet mode in Heating doesn't work when
equipped with a wired remote controller.
• ON/OFF reserve mode doesn't work
when equipped with a wired remote
controller.