Clatronic DB 2971 Instrucciones De Servicio/Garantía página 36

Caution: the steam is hot. Danger of scalding!
GB
When ironing at low temperatures, make sure that you reduce the quantity of
steam or iron without steam. If the temperature is too low water may leak from the
soleplate.
Refi lling the water tank
• Always disconnect the mains plug before refi lling water.
• Set the steam control (4) to "O" (no steam). Open the lid of the refi ll inlet (6)
and carefully pour in the water. Do not exceed the maximum line as marked on
the water reservoir.
Spray Function (
In order to moisten a section to be ironed press the spray button (5).
Self-Cleaning (
1. Half fi ll the water tank with water.
2. Heat the machine up to its maximum temperature. After the control lamp goes
off remove the machine from the mains supply.
3. Now hold the iron horizontally over a sink. Hold the steam control in the „Self-
Cleaning " position. Now rock the device backwards and forwards until the
tank is empty. Then return the regulator to the O position.
4. Place the machine back on its stand and heat it up again. To clean the base
now iron over a clean cotton cloth.
• Always remove the mains lead before cleaning!
• Clean the casing with a slightly damp cloth.
• Clean the iron with a slightly humid cloth.
• Always return the steam regulator to the „O" position after use and empty the
water tank in order to prevent any leaks.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
36
6....-05-DB 2971 36
)
)
Cleaning and Storage
23.12.2004, 10:56:03 Uhr