Descargar Imprimir esta página

Indesit IDCE 8454X A Manual De Instrucciones página 38

Publicidad

Idiomas disponibles

Idiomas disponibles

ON/OFF/Reset button
Pressing the button normally will cause the machine to switch on or off. If the button is pressed for 3 seconds while the dryer is in use,
EN
the machine will switch off and the running cycle will reset.
Programme selection knob
Allows for setting the programme: turn until the indicator points towards the desired programme (see Starting and selecting a programme).
Options buttons
Allows selection of the options available for the selected programme. The respective indicator lights turn on when the option has been
selected (see Programmes and options).
START/PAUSE button and indicator light
When the green light flashes slowly, press the button to start the programme. When the cycle is under way, the indicator light re-
mains on. Press the button again to put the programme in the pause mode; the indicator light turns orange and starts flashing again.
Press the button again to resume the programme from the point it was interrupted (see Starting and selecting a programme).
Display
In section A, the selected "Timed drying" value is displayed; if the "Delay start" function was set, the time remaining to the start of the
selected programme will appear.
The duration of the selected programme is also displayed in this section.
In section B, the phase of the running programme is displayed:
: Drying cycle
Sun icon
Fan icon
: Cold air cycle
In section C, the maintenance indicator lights are displayed (Empty water container indicator light
, Clean filter indicator light
,
Clean Heat pump filter unit indicator light
), see Indicator lights.
C
B
A
Indicator lights
The indicator lights provide important information. They indicate the following:
The "Empty water container" indicator light
signals that the water container must be emptied.
If the water container fills during the course of the programme, the LED lights up. The dryer automatically starts a cold air cycle and
the START/PAUSE LED flashes orange. Press the START/PAUSE button to resume the cycle from the point it was interrupted.
In order to avoid this procedure, always empty the water container after using the tumble dryer (see Maintenance).
Before each programme, the "Clean filter" indicator light
signals the fundamental importance of cleaning the filter before each load
(see Maintenance).
The "Clean Heat pump filter unit" indicator light
indicates that you must clean the Heat pump filter every 5 cycles (however, we
recommend you clean it after each cycle).
38

Publicidad

loading