Descargar Imprimir esta página

Indesit IDCE 8454X A Manual De Instrucciones página 35

Publicidad

Idiomas disponibles

Idiomas disponibles

Heat Pump Filter Unit - You must clean the fluff
from the filter every five drying cycles to maintain
the correct functioning of your dryer !
However for optimum performance and to save
energy we recommend that it is cleaned before
each drying cycle.
! Warning: The front of the heat pump is made from thin
metal plates.
Take care that you do not damage these or cut yourself
when cleaning, removing or replacing the filter unit.
Step 1
Open the heat pump filter
Cover.
- hold the handle and pull
towards you.
Step 2
Remove the filter unit by
rotating the 4 clips to the
vertical position then pulling
the filter unit towards you.
(There may be some water in
the filter this is normal).
Step 3
If there is any build up of
fluff on the plates Carefully
clean this off with a damp
cloth, sponge or vacuum
cleaner.
Never use your Fingers.
Step 4
Seperate the two parts of
the filter unit, clean any fluff
deposits from the inside
surface of the filter mesh.
Clean the seals.
Assemble the two parts.
Step 5
Refit the filter unit - ensure that the unit is pushed in fully,
then turn all 4 clips into the horizontal position to lock the
cover.
Failure to clean Heat Pump Filter will reduce the
drying performance and could cause premature
failure of your dryer.
To maintain optimum drying performance we
recommend you clean this filter after every drying
cycle.
EN
35

Publicidad

loading