ADE CK 2302 Instrucciones De Operación página 26

Other functions
Other functions
Change temperature unit
− Press the
button to toggle between the degrees Celsius (°C) and degrees
Fahrenheit (°F).
Switching between summer and winter time
Switching between summer and winter time, or vice versa, takes place automatically
with good time signal reception. You must otherwise set the time manually.
Resetting the radio-controlled clock to factory setting
Reset the radio-controlled clock to its factory setting if the display shows unusual or
obviously incorrect values.
1. Remove the batteries from the battery compartment and wait a moment.
2. Reinsert the batteries.
Pay attention to the correct polarity of the batteries (+/-).
3. Proceed as described in the chapter "Receiving the time signal".
Changing the battery
When the unit reads the battery voltage below 2.5 V (display shows
change the batteries. You should then proceed as described in the "Start-up" section.
Cleaning
NOTE on material damage
− Do not immerse the clock in water or other liquids.
− Never use harsh, scouring or abrasive cleaning agents or the like to
clean the clock. Otherwise, the surface could be scratched.
− Remove dust from the radio-controlled clock by a soft, dry cloth as needed. The
glass can also be cleaned with commercially available glass cleaners.
26
), you should
CK 2302 DCF radio-controlled clock