HOMCOM 370-115V70 Instrucciones De Montaje página 9

- Place the DC plug into the power socket, then put the charger into the plug.
Never use the product when charging.
- It is normal for charger and battery to stay cool when charging.
- Do not use the connector near water to avoid damage.
- Only use the supplied charger. Using a charger not supplied by the
manufacturer can damage the product.
- When not in use for a long time, charge the product.
Problem
The car does not start.
The battery does not
charge.
The car doesn't drive far.
There's a slight noise
and the car heats when
charging.
The car operates at a
slow speed.
Charging:
Troubleshooting
Cause
- The battery is low.
- Failure to press the switch
button correctly.
- Power connector failure.
- Battery breakdown.
- Electrical devices are
damaged.
- Generator is faulty.
- Battery connector failure.
- Charger doesn't charge.
- Faulty charger.
- Battery isn't fully charged.
- Overused battery.
- This is normal.
- Overused battery.
- The battery is dead.
- The product has exceeded
its maximum load.
- Uneven driving surface.
9
Solution
- Ensure battery is fully
charged.
- Follow instructions when
using this product.
- Reinstall the power
connector.
- Change battery.
- Change electrical
devices.
- Change generator.
- Reinstall the connector.
- Plug in the charger again.
- Change the charger.
- Ensure the battery is fully
charged.
- Change the battery.
- Nothing needs to be
done.
- Change the battery.
- Ensure battery is fully
charged.
- Ensure the weight is
below 30kg.
- Drive on a flat and even
surface.