Descargar Imprimir esta página

ECCOTEMP EL10 Instalación, Uso Y Cuidado página 19

Ocultar thumbs Ver también para EL10:

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical Wiring
This connection is for low-voltage batteries or direct current only. Do not connect 120 or 240 volts AC.
Display
Temperature sensor
Battery box
NOTICE - If any of the original wire as supplied with the appliance shall be
replaced, it shall be replaced with the original type wire or its temperature
equivalent.
Replacement Parts
For more available parts for your Eccotemp Water Heater and to
purchase, visit www.eccotemp.com/parts or call 1-866-356-1992.
REPLACEMENT PART
Shower
Nozzle
and Hose
1/2" NPT
to Garden
Hose
Adapter
Gas Hose
and
Regulator
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED, NOR HAS IT BEEN TESTED FOR ANY PERMANENT OR INDOOR INSTALLATION. THIS
MODEL IS PART OF OUR PORTABLE, OUTDOOR SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM, DRY PLACE AFTER EVERY
USE. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. VISIT SUPPORT.ECCOTEMP.COM FOR THE
Shop Online: Eccotemp.com
Ignition pin
HV1
On/Off Switch
Solenoid
Micro switch
SKU
501026
502028
502005
LATEST VERSION OF THE MANUAL AND WARRANTY.
Support: Support.Eccotemp.com
Sensor pin
HV2
S
Ignition controller
CAUTION: Label all wires prior to
disconnection when servicing controls.
Wiring errors can cause improper and
dangerous operation.
REPLACEMENT PART
Hardware
Pack
Pressure
Relief
Valve
Store Locator: Eccotemp.com/locator
Ground wire
Over temp sensor
SKU
201032
JPRV12
19

Publicidad

loading

Este manual también es adecuado para:

El7El5El10nr