Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-SPC-A-WTD Series
INSTALLATION OF MAGNETIC VERSION
NOTE: The fixture is intended for 120V operation only.
NOTE: See Figure 7 for parts of fixture.
1. Remove handle screw from fixture, position handle, and use screw to
attach handle to fixture. See Figure 2.
2. Attach fixture to the side wall of a shipping container by bringing the
magnet close to the wall. Make sure chosen location is near enough
to an appropriately rated 3-prong outlet to allow the cord to be
plugged in. See Figure 8.
CAUTION: Magnet is strong. DO NOT place fingers or the power
cord between the magnet and the mounting surface.
3. Plug fixture into an appropriately rated 3-prong outlet. Use the ON/
OFF switch to operate the fixture.
4. To aim the fixture, loosen the hand knobs on the sides and adjust
as desired. Tighten the hand knobs to secure fixture in place. See
Figure 9.
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could void
your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved could void your
authority to use this equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
FIGURE 5
http://lighting.cree.com/warranty
Document:
LPN00711X0001A0_A
Created By:
TMT
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
|
1-800-236-6800
Date
4-05-2023
FIXTURE YOKE
Publicidad
