N-Gear LGP JUKE 101 Manual De Operación página 6

Button instruction
:
1. TWS button
1.1 Single click to enter /exit into TWS connection
1) Prepare two speaker ,single click this button for both of them,will hear a voice prompt. ( PS:Please
make sure the speaker is disconnected with any wireless device before using TWS function. )
2)Then wait for a few seconds, will hear a voice prompt after two speaker connected with each other
successfully. Search for the bluetooth ID to connect with bluetooth device.
3)After connected with bluetooth device, operate either speaker,the other one will be synced.
4) Single click TWS button of either of them will exit TWS mode.
1.2 Long press to switch the play mode ,from wireless mode - TF mode - U disk mode - AUX mode. (Note:
This operation should be under TF card, U-disk, AUX all insert on the speaker in advance)