Kenwood Major KM631 Instrucciones página 6

troubleshooting
problem
The whisk or K-beater knocks against the bottom of the bowl or isn't
reaching the ingredients in the bottom of the bowl.
solution Adjust the height. Here's how:
Unplug.
1
Raise the mixer head and insert the whisk or beater.
2
Hold it, then loosen the nut
3
Lower the mixer head.
4
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
5
be almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
6
to fit and use your round/D-shaped
splashguard (if supplied)
Raise the mixer head until it locks.
1
Fit the bowl onto the base.
2
Push the splashguard on until fully located
3
should be positioned as shown round
Insert required tool.
4
Lower the mixer head ensuring the splashguard follows the shape of
5
the bowl.
During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard.
You do not need to remove the splashguard to change tools.
Remove the splashguard by raising the mixer head and sliding it down.
6
. The hinged section
and D-shaped
5