Adler europe AD 2252 Manual De Uso página 5

1. - handle 2. - speed / temperature adjustment switch
3. - wall base
USING THE DEVICE
1. Remove hair dryer form wall base (3).
2. Set desired speed/temperate by switch (2):
0 - off 1 - low speed, hot air
3. To turn the unit OFF, slide the switch on the hair dryer to the OFF position, or place hair dryer into the base (3), this will automatically
turn the hair dryer off.
INSTALLATION INSTRUCTION
Before mounting on the wall, make sure there are no hidden electrical circuits or pipes in the mounting location. Tool needed: screwdriver,
hammer and electric drill.
Included with hair dryer: 1 plastic wall base, 3 long screws and 3 expansion bolts for mounting the base, 1 metal wall-mounted plate, 1
small screw for securing the base to the metal plate.
Remove all above elements from packing.
Place the metal plate (a) on the wall where it is going to be mounted.
1. As it is natural for coiled electrical cords to "Relax" with use. It is important to mount dryer at a height location that will accommodate
several inches of extra cord length over time.
2. Hold wall metal plate (a), with two tabs on to, flush against the wall. Use wall metal plate (a) as a template to mark the location with
pencil.
3. Remove the metal plate (a) and drill holes at the markings through the plaster wall with 6 mm or 1/4" drill bit, drill approximately 32 mm
or 1-1/4" deep.
4. Push plastic expansion bolts (b) into the drilled holes so that the open ends of the expansion bolts (b) are flush with the wall.
5. Set the wall metal plate (a) against the wall, lined up over the expansion bolts (b). Screw the M4(#8) self-tapping screws (c) into the
plastic expansion bolts (b) until the metal wall plate (a) is secured tightly against the wall. See FIG.A
6. Remove hair dryer from base (3).
7. Catch the base (3) on the bent tabs (d) located on the metal wall plate (a).
8. Push the base (3) flush against the metal wall plate (a) and slide it down to affix the bent tabs (d) at the metal wall plate (a).
9. Use a single small screw to twist a metal plate (a) with the plastic base (3) in location (e). See FIG..B
CLEANING AND MAINTENANCE
1. Clean inlet cover grill (4) regularly from loose hair or other dust.
2. Dirty housing clean with wet soft cloth, then wipe to dry. Do not use any aggressive detergents.
3. Avoid any liquid to reach inside of the hair dryer.
TECHNICAL DATA
Power: 1400-1600W
Voltage: 220-240V ~50/60Hz
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
vSICHERHEITSBEDINGUNGEN WICHTIGE ANWEISUNGEN ZUR SICHERHEIT DER
VERWENDUNG BITTE SORGFÄLTIG LESEN UND ZUM SPÄTEREN NACHSCHLAGEN
AUFBEWAHREN
Bei gewerblicher Nutzung des Gerätes gelten abweichende Garantiebedingungen.
1. Bevor Sie das Produkt verwenden, lesen Sie bitte die folgenden Anweisungen sorgfältig
durch und befolgen Sie diese stets. Der Hersteller übernimmt keine Haftung für Schäden,
die durch Missbrauch entstehen.
2. Das Produkt darf nur im Innenbereich verwendet werden. Benutzen Sie das Produkt nicht
4. - inlet cover grill
2 - high speed, very hot air
DEUTSCH
5