Tabla De Contenido; Power Switch - GYS TITAN 400 DC Manual Del Operador

POWER SWITCH

• This equipment is supplied with a 3-phase 32A plug (3P+N+PE) of the type EN 60309-1 and needs to be powered by a 400V 3-phase EARTHED
power supply (50 - 60 Hz). This machine must only be used with a three phase electricity supply system with four wires and one earthed neutral.
The absorbed effective current (I1eff) is displayed on the machine, for optimal use. Check that the power supply and its protection (fuse and/or
circuit breaker) are compatible with the current needed by the machine. In some countries, it may be necessary to change the plug to allow the use
at maximum settings. The user has to make sure that the plug can be reached.
• The device turns into protection mode if the power supply tension is below or above the 15%. To indicate this default, the screen displays an error
code.
• The start is done via an on / off switch (7) set to I, and the stop is done by switching it to O. Warning ! Never disconnect the power supply
when the welding electrical distribution is in operation.
• Fan: in MMA mode, the fan works continuously. In TIG mode, the fan works only when welding, then stops after cooling.
CONNECTION TO A GENERATOR
The machine can work with generators as long as the auxiliary power matches these requirements :
- The voltage must be AC, always set as specified, and the peak voltage below 700V,
- The frequency must be between 50 and 60 Hz.
It is imperative to check these requirements as certain generators can create high voltage peaks that can damage these machines.
USE OF EXTENSION LEADS
All extension cables must have an adequate size and section, relative to the machine's voltage. Use an extension lead that complies with national
safety regulations.
FUNCTION, MENU AND PICTOGRAM DESCRIPTIONS
FUNCTION
Pre-gas
Up slope current
Welding current
Down slope current
Post-gas
Cold current/Back-
ground current)
Pulse balance
PULSE Frequency
HotStart
ArcForce
Ampere (unit)
Temps (unit)
Percentage (unit)
Volt (unit)
Hertz (unit)
KiloJoules (unit)
HF ignition
Lift ignition
MMA STD
MMA PULSE
2T
26
Current input
TITAN 400 DC 400 V
PICTOGRAM MMA TIG DC
x
x
x x
x
x
x x
x
x x
x
x
x x
x x
x x
x x
x x
x x
x
x
x
x
x
TITAN 400 DC
Thickness of the extension lead (Length < 45m)
Comment
Time to purge the torch and to protect the area with gas before ignition.
Up slope current (sec).
Welding current (A).
Down slope current.
Duration for which gas is released after the arc has stopped. It protects the weld
pool and the electrode against oxidisation when the metal is cooling down (sec).
Second welding current or «cold» current in standard 4TLOG or in PULSE mode
(%).
Balance between the cold current duration and pulse duration (%).
PULSATION frequency of the PULSE mode (Hz)
Adjustable overcurrent at the beginning of the welding (%)
Overcurrent delivered during welding (-10 to +10).
Unit of Amperes for current settings.
Unit of seconds for durations settings.
Unit of percentage for proportion settings.
Unit of Volts for voltage settings.
Unit of Hertz for frequency settings.
Unit of KiloJoules for welding energy settings.
TIG process with HF ignition.
TIG process with LIFT ignition.
Standard MMA Standard.
Pulse MMA Process.
2T torch mode.
6 mm²
EN