Remote Control - GYS TITAN 400 DC Manual Del Operador

REMOTE CONTROL

The remote control operates in TIG mode and in MMA.
ref. 045699
Connection :
1- Plug the remote control into the connection at the back of the machine.
2- The interface will detect automatically the remote control and open a selection menu :
Pressing the scroll wheel validates the choice of type of remote controller and allows to go back to stand-by mode.
Connection
The TIG 300 DC is equipped with a female socket for a remote control.
The specific 7 pin male plug (option ref.045699) enables connection to the different types of manual remote control or foot pedal. For the cabling
layout, please see the diagram below.
TYPE DE COMMANDE À DISTANCE
CONNECT-5
Operating :
• Manual remote control (option ref. 045675).
The remote control enables the variation of current from 50% to 100% of the set intensity In this configuration, all modes and functions of the
machine are accessible and can be set.
• Foot pedal (option ref. 045682) :
The pedal control enables variation of the current from the minimum current to 100% of the set intensity.
In TIG, the welding machine only operates in 2T mode. The upslope and downslope are not automatically managed by the current source, and are
controlled by the user with the foot pedal.
• CONNECT 5 - automaton mode :
This mode enables to pilot the machine from a console or from an automaton using the 5 pre-saved programs.
For the foot pedal, the «Switch (D)» enables to start or stop welding according to the chosen cycle. The voltage value for the «slider (B)» matches
a program or the actual status.
The voltage must be between 0 and 10.0V by step of 1.6V matching program reminder :
- Current context : 0 – 1.6 V
- Program 1 : 1.7 – 3.3 V
- Program 2 : 3.4 – 5.0 V
- Program 3 : 5.1 – 6.6 V
- Program 4 : 6.7 – 8.3 V
- Program 5 : 8.4 – 10.0 V
TITAN 400 DC
G
F
A
B
E
D C
External view Electric diagram according to the remote control type.
A command is shown but not active.
Remote control with potentiometer selection.
Remote control with potentiometer selection.
Commande à distance
Pédale
D
045682
C
B
045675
A
Désignation du fil
Curseur
manuelle
Commun/Masse
Switch / Interrupteur
AUTO-DETECT
ARC ON
Pin du connecteur
associée
10 V
REG I
EN
A
B
C
D
E
F
G
35