Publicidad
Idiomas disponibles
Idiomas disponibles
44 42 04 07/13 /
Packing list: 1 Cable set
1 Socket
1 Socket retaining plate
1 Rubber grommet
1.
Disconnect the earth lead from the battery
2.
Remove inside screens of boot near tail lights of vehicle.
3.
In order to draw electric bunch to connection socket, drill a hole of 6 mm diameter in rear vehicle wall (e.g. opposite
to connection socket). Increase the diameter to 20mm. Secure edge with anti-corrosion agent.
4.
Connect bunch to socket in the following way:
a) Draw end of cable bunch with metal connections of cables through the place referred to in point 3 from boot
outside and through a hole near socket connection handle, fasten supplied grommet in the drilled hole,
b) Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),
c) Disassemble the socket and connect cables according to the following assignment:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
13 pin
Function
Indicator left
Trailer fog light
Rear fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a) Pay special attention to the right position of rubber retaining plate,
b) Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
7-pin
13-pin
3 Screws M5X35
3 Nuts M5
3 Spring washer
8 Cable ties
Installation instruction
Contact description
Cable colour
1
(L)
black/white
2
(54-G)
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
8
(58-b)
Contact description
Cable colour
1
black/white
2
2a
3
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
rown 2,5mm
12
13
white/brown 2,5mm
Part no. 006-848
VW Polo manufactured 09.81- 07.90
VW Golf I and II i Cabrio manufactured 09.81-
VW Jetta I and II manufactured 09.81-
VW Passat liftback, sedan and Variant
manufactured 08.80 - 05.88
Part no. 008-648
VW Golf II manufactured 08.83-
VW Jetta II manufactured 02.84-
3 Quick connector (only in 7-pin version)
2 Heat shrinkable tube (only in 7-pin version)
1 Quick connector blue (only in 7-pin version)
2 1-input casing (only in 13-pin version)
2
2
2
2
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
8
9
7
1
10
6
2
4
3
5
11
12
13
2a
Contact description in
13-pin socket
Publicidad
