Publicidad
Idiomas disponibles
Idiomas disponibles
Fit the foot rails
A
(
)
Locate and remove the two rear Plastic
Covers found each side in the Ditch
Moulding of the vehicle's roof. This is done
my pushing the covers in the direction of the
arrows found on the covers, and lifting.
B
(
)
Remove the two bolts and steel bracket below each Plastic Cover removed in Step 2A.
( C )
Clean the area around the threaded holes in the vehicle's roof using a rag and some methylated spirits /
denatured alcohol. Place some silicone around each threaded hole in the vehicle's roof and the two
cut-outs in each of the Spacers (Item 8) as shown. Position the Spacers into the vehicle's gutters, lining
up the cut-outs in the Spacers with the threaded holes in the vehicle roof.
D
(
)
Place the Foot Rails onto the vehicle's roof, lining up the mounting holes in the bottom of the Foot Rails
with the mounting points on the vehicle. The Product Sticker must go to the rear of the vehicle and must
be facing outwards. Push the Foot Rails as far back as possible.
REV_A00
Silicone
3
Publicidad
