Go Rhino 915003T Instrucciones De Instalación página 4

Ingl é s
INSTALLATION INSTRUCTIONS
STEP #1
Tubes are stamped D
(Driver) P (Passenger)
• Assemble the central body with the front and rear tubes,
side at 90 ° of the tube with the central body
spacers specified with the front and rear tube.
• Attach each tube to the body using (2) ¼" metal spacers, (2) 3/8" flat
washers, (2) 3/8" lock washers and (2) 3/8" hex bolts per side.
• Do not fully tighten bolts, leave loose for final adjustments.
• Tubes are stamped D (driver) P (passenger)
STEP #2
• Assemble the Lateral bodies with the
front and rear tubes as shown. Use the
plastic and metal spacers specified
with the front and rear tube.
• Attach each tube to the body using (2)
¼" metal spacers, (2) 3/8" flat
washers, (2) 3/8" lock washers and
(2) 3/8" hex bolts per side.
• Do not fully tighten bolts, leave loose
for final adjustments.
REV.01
. Use the plastic and metal
© 2016 Go Rhino Products. All rights reserved
align the cut
4