Publicidad
Idiomas disponibles
Idiomas disponibles
Menu Item
Description
[Dimmer Duration]
Adjust the time that the dimmer is turned on or off by
dragging the cursors or touching
You can use this function when [Dimmer Trigger] is set to
[Time].
TIPS
• Each touch of
forwards in the 15 minute width.
• When the cursors are placed on the same point, the dimmer
available time is 0 hours.
• When the cursor for off time setting is placed on the left end and
the cursor for on time setting is placed on the right end, the
dimmer available time is 0 hours.
• When the cursor for on time setting is placed on the left end and
the cursor for off time setting is placed on the right end, the
dimmer available time is 24 hours.
NOTE
The time display of the dimmer duration adjusting bar depends on
the clock display setting (page 47).
[Picture Adjustment]
You can adjust the picture for each source and rear view camera.
CAUTION
For safety reasons, you cannot use some of these functions while your vehicle is in motion. To enable
these functions, you must stop in a safe place and apply the handbrake.
To adjust following menu, touch
Menu Item
Description
[Brightness]
Adjust the black intensity.
[-24] to [+24]
[Contrast]
Adjust the contrast.
[-24] to [+24]
[Colour]*
Adjust the colour saturation.
[-24] to [+24]
[Hue]*
Adjust the tone of colour (which colour is emphasised, red,
[-24] to [+24]
or green).
[Dimmer]
Adjust the brightness of the display.
[+1] to [+48]
[Temperature]
Adjust the colour temperature, resulting in a better white
[-3] to [+3]
balance.
40
En
or
.
or
moves the cursor backwards or
,
,
,
to adjust.
* With some pictures, you cannot adjust [Hue] and [Colour].
NOTES
• The adjustments of [Brightness], [Contrast], and [Dimmer] are stored separately when your vehicle's
headlights are off (daytime) and on (nighttime).
• [Brightness] and [Contrast] are switched automatically depending on the setting of [Dimmer
Settings].
• [Dimmer] can be changed the setting or the time to switch it to on or off (page 39).
• The picture adjustment may not be available with some rear view cameras.
• The setting contents can be memorised separately.
[System Information]
Menu Item
Description
[Firmware Information]
Displaying the firmware version.
[Firmware Update]
CAUTION
• The USB storage device for updating must contain only the
correct update file.
• Never turn this product off, disconnect the USB storage device
while the firmware is being updated.
• You can only update the firmware when the vehicle is stopped
and the handbrake is engaged.
1
Download the firmware update files into your
computer.
2
Connect a blank (formatted) USB storage device to
your computer then locate the correct update file and
copy it onto the USB storage device.
3
Connect the USB storage device to this product
(page 26).
4
Turn the source off (page 17).
5
Display the [System] setting screen (page 36).
6
Touch [System Information].
7
Touch [Firmware Update].
8
Touch [Continue].
Follow the on-screen instructions to finish updating the
firmware.
NOTES
• This product will reset automatically after the firmware
update is completed if the update is successful.
• If an error message appears on the screen, touch the
display and perform the above steps again.
[Licence]
Displaying the open source licence.
Publicidad
