ADE CK 2308 Instrucciones De Operación página 23

3. Wait until the radio-controlled clock automatically switches to receiving mode at
a later point in time. The reception is usually better at night.
4. Manually perform the settings if reception is not possible at your location,
see "Setting the time and date manually".
Starting signal reception of the time signal manually
If the radio signal symbol to the left is no longer displayed, the radio signals
from the time signal transmitter are no longer being received. The time
indicator nevertheless continues precisely.
− Press the
button. The signal reception is thus started manually.
Pay attention to the following:
‚ If the reception was not successful, the reception symbol fades out after a few
minutes and the time on the display continues normally.
‚ Upon successful signal reception, the radio-controlled clock adjusts itself to the
time of the time signal transmitter. If you have already made manual time and date
settings, they will be adjusted automatically.
Setting the time and date manually
‚ If there is more than approx. 20 seconds between two pushes of a
button, the setting process automatically ends and you will have to
repeat it.
‚ If you press and hold the
increased or decreased more quickly.
1. Press and hold down the
2. Use the or button to set whether a beep should follow each press of a button
("ON" = default setting) or switch this function off ("OFF").
3. Press to save the setting. "00" flashes in the display for the time zone you are in
("00" is the default setting for the European mainland).
4. Proceed as previously described:
− Press the
or
− Press
to save a setting.
5. You should set the following:
− Hours
− Minutes
− Year
− Month
CK 2113 | CK 2308 XL radio-controlled wall clock
or
button until "BEEP ON" appears on the display.
button to set the desired value.
Receiving the time signal
buttons, the displayed values will be
23