ADE CK 2308 Instrucciones De Operación página 26

Alarm
Switches the alarm function on/off
1. Press the button once or twice to select the respective alarm ("AL1" or "AL2").
2. Use to set the display to "ON". The display shows e.g.
selected setting). The alarm function is activated.
To disable the alarm function, proceed as described and then use
the display to "OFF" with the alarm function enabled.
Waking up
At the set time, you will be woken by an alarm signal, which will become more intense
as the waking time increases.
Interrupting the alarm for 24 hours
− Keep the
the alarm.
After 24 hours, the alarm will be triggered again.
Auto-stop function
If you do not press a button, the alarm switches off automatically after 2 minutes.
After 24 hours, the alarm will be triggered again.
Repeat alarm (snooze function)
− Briefly tap the
The alarm signal will be muted and the flashing bell symbol
appear on the display.
The device will switch on again according to the selected setting (the default setting is
5 minutes) to wake you up again. This procedure can be repeated multiple times.
To disable the snooze function, press any button on the side or keep
pressed for a few seconds during the snooze phase. The alarm is then only
triggered again in 24 hours.
26
sensor field pressed for a few seconds or press any button to stop
sensor field once when the alarm signal sounds.
(depending on the
CK 2113 | CK 2308 XL radio-controlled wall clock
to set
or and will